An H.323 Gatekeeper serves the purpose of Call Admission Control and translation services from E.164 IDs (commonly a phone number) to IP addresses in an H.323 telephony network. Gatekeepers can be combined with a gateway function to proxy H.323 calls and are sometimes referred to as session border controllers (SBC). A gatekeeper can also deny access or limit the number of simultaneous connections to prevent network congestion.
H.323 endpoints are not required to register with a gatekeeper to be able to place point to point calls, but they are essential for any serious H.323 network to control call prefix routing and link capacities among other functions.
A typical H.323 Gatekeeper call flow for a successful call may look like:-
| | | | Endpoint A Endpoint B 1234 1123
- Endpoint A dials 1123 from the system.
- Endpoint A sends ARQ (Admission Request) to the Gatekeeper.
- Gatekeeper returns ACF (Admission Confirmation) with IP address of endpoint B.
- Endpoint A sends Q.931 call setup messages to endpoint B.
- Endpoint B sends the Gatekeeper an ARQ, asking if it can answer call.
- Gatekeeper returns an ACF with IP address of endpoint A.
- Endpoint B answers and sends Q.931 call setup messages to endpoint A.
- IRR sent to Gatekeeper from both endpoints.
- Either endpoint disconnects the call by sending a DRQ (Disconnect Request) to the Gatekeeper.
- Gatekeeper sends a DCF (Disconnect Confirmation) to both endpoints.
The gatekeeper allows calls to be placed either: Directly between endpoints (Direct Endpoint Model), or Route the call signaling through itself (Gatekeeper Routed Model).
See also
Sources
- Cisco Technotes: Understanding H.323 Gatekeepers
- Microsoft TechNet: H.323 Gatekeeper
- Packetizer: A Primer on the H.323 Series Standard
 | This network-related software article is a stub. You can help Misplaced Pages by expanding it. |