Misplaced Pages

CubETH

Article snapshot taken from Wikipedia with creative commons attribution-sharealike license. Give it a read and then ask your questions in the chat. We can research this topic together.
Swiss satellite project
CubETH
Mission typeSatellite navigation
Technology demonstration
OperatorETH Zurich
Mission duration18 months planned
Spacecraft properties
Spacecraft type1U CubeSat
Launch mass1.388 kilograms (3.06 lb).
Orbital parameters
Semi-major axis6,830 kilometres (4,240 mi) to 6,930 kilometres (4,310 mi)

CubETH is a Swiss satellite project. As of 2015, it is being developed by several Swiss academic and industrial partners. The spacecraft is a single unit CubeSat and therefore 10 x 10 x 10 cm (3.9 x 3.9 x 3.9 in) in size. Its main goal is to prove the feasibility of attitude and orbit determination with low cost commercial off-the-shelf GNSS-receivers.

Aims

CubETH is a technology demonstration mission. The first goal is to prove that low cost receivers can be used for positioning in space. The orbit as well as the attitude of the spacecraft will be computed on board the satellite and send to a station on earth. The post-processing of the data will allow a first plausibility check. In order to fulfil an external validation, CubETH will be equipped with satellite laser ranging reflectors for range measurements from ground stations.

Satellite structure

The upper face of the satellite will be equipped with four GNSS antennas. The four side faces hold the solar panels for electricity generation. A fifth GNSS antenna is mounted on one of the lateral faces. The communication antenna is located on the lower, earth looking face. The whole flight electronics is located inside the satellite. In addition to the five GNSS antennas and the SLR-reflectors, The payload consists of the GNSS receivers and the necessary hardware. The GNSS receiver chips are developed and manufactured by the Swiss company U-blox. The main advantage of these commercial chip-sets is the low power consumption and the small size. However, the chips are not certified for space applications and a risk assessment is part of the project. For redundancy reasons, the satellite is equipped with ten receivers, each antenna being connected to two of them.

Project partners

The Geodesy and Geodynamics Lab of ETH Zurich holds the scientific leadership and is responsible for the payload data processing software. EPFL and the Swiss Space Center (SSC) are in charge of project management and the realization of the satellite bus. Lucerne University of Applied Sciences and Arts develops the payload hardware and the ground station. RF and antenna-design is provided by Hochschule für Technik Rapperswil. Further project partners are HES-SO (academic partner), u-blox (industrial partner), RUAG Space (industrial partner) and Saphyrion (industrial partner).

Status

CubETH is currently under development. The launch was planned for 2017.

See also

References

  1. ^ Ivanov et al. (2014) "CubETH: low cost GNSS space experiment for precise orbit determination". Proceedings of: Small Satellites Systems and Services Symposium, Porto Petro, Majorca, Spain
  2. Willi et al. (2015) "The Cube Satellite Mission CubETH". Swiss National Report on the geodetic activities, IUGG, p. 217
  3. "Raumschiffchen vom Hönggerberg" Tages Anzeiger (in German)]
Categories: