First flush

Initial surface runoff of a rainstorm For first flush tea, see Tea § Cultivation and harvesting.

First flush is the initial surface runoff of a rainstorm. During this phase, water pollution entering storm drains in areas with high proportions of impervious surfaces is typically more concentrated compared to the remainder of the storm. Consequently, these high concentrations of urban runoff result in high levels of pollutants discharged from storm sewers to surface waters.

First flush effect

The term "first flush effect" refers to rapid changes in water quality (pollutant concentration or load) that occur after early season rains. Soil and vegetation particles wash into streams; sediments and other accumulated organic particles on the river bed are re-suspended, and dissolved substances from soil and shallow groundwater can be flushed into streams. Recent research has shown that this effect has not been observed in relatively pervious areas.

The term is often also used to address the first flood after a dry period, which is supposed to contain higher concentrations than a subsequent one. This is referred to as "first flush flood." There are various definitions of the first flush phenomenon.

First foul flush

Storm water runoff in a combined sewer produces a first foul flush with a suspension of accumulated sanitary solids from the sewer in addition to pollutants from surface runoff. Inflow may produce a foul flush effect in sanitary sewers if flows peak during wet weather. As flow rates increase above average, a relatively small percentage of the total flow contains a disproportionately large percentage of the total pollutant mass associated with overall flow volume through the peak flow event. Sewer solids deposition during low flow periods and subsequent resuspension during peak flow events is the major pollutant source for the first-flush combined-sewer overflow (CSO) phenomenon.

Sanitary sewage solids can either go through the system or settle out in laminar flow portions of the sewer to be available for washout during peak flows. The wetted perimeter of sewers may also be colonized by biofilm nourished by soluble sanitary wastes. Hydraulic design is the underlying reason for solids deposition in sewers. Combined sewers sized for peak runoff events expected once a decade can carry up to 1,000 times the average sanitary flow. Less dramatically oversized sewers are common in new developments and near the upstream end of collection systems. Suspended solids may accumulate when low-flow fluid velocities generate insufficient turbulence. Solids deposition is greatest where velocities are low during dry weather. In large combined sewers it may be impossible to attain sanitary sewage velocities generating sufficient turbulence to keep solids suspended during dry weather.

Biofilm and previously deposited solids may be scoured and re-entrained during peak flow turbulence. The high pollution load in wastewater at the beginning of a runoff event occurs when increased flow rate erodes accumulated sewer sediment. Erosion of sediments in sewers can release pollutants in concentrations exceeding levels found in contributing sources. The initial highly polluting foul flush is released at the start of wet weather flow during speedy erosion of a weak layer of highly concentrated surficial sediment bed-load. When conditions favor dry-weather solids deposition, the first foul flush may contain as much as 30 percent of the annual total suspended solids discharged to a combined sewer system. Combined sewer suspended solids concentrations of several thousand milligrams per liter (mg/L) may be observed during the first foul flush.

Pollutant concentration levels are influenced by the age and condition of the collection system and the amount of infiltration/inflow in comparison to the sanitary flow. Pollutant concentration peaks depend on size and slope of the piping system, time interval between storms, and solids accumulation in the collection system. Steeper sewer gradients and pipe bottom shapes that maintain high velocity flow during low-flow conditions will reduce sediment accumulation in sewers; and periodic sewer flushing of individual lines during dry weather may move accumulated solids to the wastewater treatment plant before stormwater runoff causes simultaneous peak flow in the entire collection system.

Related terms

Because the reference of the first flush is not always clear, the terms "concentration-based first flush" (CBFF) and "mass-based first flush" (MBFF) have been introduced.

Apart from this definition, there are a number of rating parameters in literature to determine the occurrence of a first flush.

Rainwater harvesting

In the context of rainwater harvesting, a first flush diverter is a simple device that is designed to protect a storage cistern from contamination by first flush runoff. This leads to a higher quality of water captured, and less silting of the cistern over time in dusty areas. The diverted first flush water is used for irrigation or other purposes in a fashion similar to greywater. Although many commercial versions are available, these devices are frequently constructed of spare pipe when the cistern is initially installed or thereafter. See Texas Manual on Rainwater Harvesting for calculations on sizing.

References

Metcalf, Leonard; Eddy, Harrison P. (1916). American Sewerage Practice: Disposal of Sewage. Vol. III. New York: McGraw-Hill. p. 154.
^ Alex Maestre and Robert Pitt; Center for Watershed Protection (2005)."The National Stormwater Quality Database, Version 1.1: A Compilation and Analysis of NPDES Stormwater Monitoring Information." Archived 2016-03-03 at the Wayback Machine Report prepared for U.S. Environmental Protection Agency (EPA), Washington, DC. September 4, 2005.
Australian Government, Department of the Environment and Heritage. Canberra. "Glossary of Terms."
Gupta, K.; Saul, A.J. (1996). "Specific Relationships for the First Flush Load in Combined Sewer Flows". Water Research. 30 (5): 1244–1252. Bibcode:1996WatRe..30.1244G. doi:10.1016/0043-1354(95)00282-0. ISSN 0043-1354.
Geiger, W. (1987). "Flushing Effects in Combined Sewer Systems". Proc. 4th Int. Conf. Urban Drainage, Lausanne, Switzerland: 40–46.
^ Fan, Chi-Yuan; Field, Richard; Lai, Fu-hsiung (2003). Sewer-Sediment Control: Overview of an EPA Wet-Weather Flow Research Program (Report). EPA. EPA 600/J-03/188.
Fraser, A.G.; Sakrabani, R.; Ashley, R.M.; Johnstone, F.M. (2002). "Managing sewer solids for the reduction of foul flush effects--Forfar WTP". Water Science & Technology. 45 (3). US National Library of Medicine National Institutes of Health: 265–272. doi:10.2166/wst.2002.0087. PMID 11902479.
Sakrabani, Ruben; Vollertsen, Jes; Ashley, Richard M.; Hvitved-Jacobsen, Thorkild. "Biodegradability of Organic Matter associated with Sewer Sediments during First Flush" (PDF). White Rose Research Online. University of Sheffield. Retrieved 12 March 2016.
Ashley, R.M.; Wotherspoon, D.J.J.; Coghlan, B.P.; McGregor, I. (1992). "The Erosion and Movement of Sediments and Associated Pollutants in Combined Sewers". Water Science & Technology. 73 (5). IWA Publishing: 101–114. doi:10.2166/wst.1992.0184.
Combined Sewer Overflow Control Manual (Report). EPA. September 1993. pp. 5, 9–10&19. EPA/625/R-93/003.
^ Sansalone, John; Christina, Chad M. (November 2004). "First flush concepts for dissolved solids in small impervious watersheds". Journal of Environmental Engineering. 130 (11): 1301–1314. doi:10.1061/(ASCE)0733-9372(2004)130:11(1301). ISSN 0733-9372.
University of Hawai`i Agricultural Extension. Manoa, HI (2008). "Rainwater Catchment Solutions: First-Flush Diverters." Brochure.
Texas Manual on Rainwater Harvesting (PDF) (Report) (3rd ed.). Austin, TX: Texas Water Development Board. 2005. pp. 8–9.

External links

Stormwater first flush pollution - New South Wales Environment Protection Authority, Australia

v t e Rivers, streams and springs
Rivers (lists)	Alluvial river Braided river Blackwater river Channel Channel pattern Channel types Confluence Distributary Drainage basin Subterranean river River bifurcation River ecosystem River source Tributary
Streams	Arroyo Bourne Burn Chalk stream Coulee Current Stream bed Stream channel Streamflow Stream gradient Stream pool Perennial stream Winterbourne
Springs (list)	Estavelle/Inversac Geyser Holy well Hot spring list list in the US Karst spring list Mineral spring Ponor Rhythmic spring Spring horizon
Sedimentary processes and erosion	Abrasion Anabranch Aggradation Armor Bed load Bed material load Granular flow Debris flow Deposition Dissolved load Downcutting Erosion Headward erosion Knickpoint Palaeochannel Progradation Retrogradation Saltation Secondary flow Sediment transport Suspended load Wash load Water gap
Fluvial landforms	Ait Alluvial fan Antecedent drainage stream Avulsion Bank Bar Bayou Billabong Canyon Chine Cut bank Estuary Floating island Fluvial terrace Gill Gulch Gully Glen Meander scar Mouth bar Oxbow lake Riffle-pool sequence Point bar Ravine Rill River island Rock-cut basin Sedimentary basin Sedimentary structures Strath Thalweg River valley Wadi
Fluvial flow	Helicoidal flow International scale of river difficulty Log jam Meander Plunge pool Rapids Riffle Shoal Stream capture Waterfall Whitewater
Surface runoff	Agricultural wastewater First flush Urban runoff
Floods and stormwater	100-year flood Crevasse splay Flash flood Flood Urban flooding Non-water flood Flood barrier Flood control Flood forecasting Flood-meadow Floodplain Flood pulse concept Flooded grasslands and savannas Inundation Storm Water Management Model Return period
Point source pollution	Effluent Industrial wastewater Sewage
River measurement and modelling	Baer's law Baseflow Bradshaw model Discharge (hydrology) Drainage density Exner equation Groundwater model Hack's law Hjulström curve Hydrograph Hydrological model Hydrological transport model Infiltration (hydrology) Main stem Playfair's law Relief ratio River Continuum Concept Rouse number Runoff curve number Runoff model (reservoir) Stream gauge Universal Soil Loss Equation WAFLEX Wetted perimeter Volumetric flow rate
River engineering	Aqueduct Balancing lake Canal Check dam Dam Drop structure Daylighting Detention basin Erosion control Fish ladder Floodplain restoration Flume Infiltration basin Leat Levee River morphology Retention basin Revetment Riparian-zone restoration Stream restoration Weir
River sports	Canyoning Fly fishing Rafting River surfing Riverboarding Stone skipping Triathlon Whitewater canoeing Whitewater kayaking Whitewater slalom
Related	Aquifer Aquatic toxicology Body of water Hydraulic civilization Limnology Riparian zone River valley civilization River cruise Sacred waters Surface water Wild river
Rivers by length Rivers by discharge rate Drainage basins Whitewater rivers Flash floods River name etymologies Countries without rivers

v t e Sewerage
Types	Combined sewer Decentralized wastewater system Drain-waste-vent system Effluent sewer Force main Gravity sewer Outfall Pressure sewer Sanitary sewer Simplified sewerage Storm drain Vacuum sewer
Construction materials	Asbestos cement pipe Brickwork Cast iron pipe Concrete pipe Culvert Interceptor ditch Plastic pipe Reinforced concrete Steel pipe Vitrified clay pipe
Related equipment	Chopper pumps Combined sewer overflow Grease trap Grinder pump Maceration Lift station Sanitary manhole Sewage pumping Sewer dosing unit Sewer gas destructor lamp Stormwater detention vault Submersible pump Sump pump Trap
Problems	Biogenic sulfide corrosion Blocked Sewer Fatberg First flush Infiltration/Inflow Sanitary sewer overflow Sewer fly Sewer gas Sewer rat
Liquids transported	Blackwater (waste) Greywater Industrial wastewater Sewage Stormwater
Background	History of water supply and sanitation

Categories:

Misplaced Pages