Names | |
---|---|
IUPAC name Lead(II) oxide | |
Other names
Lead monoxide Litharge Massicot Plumbous oxide Galena | |
Identifiers | |
CAS Number | |
3D model (JSmol) | |
ChEBI | |
ChemSpider | |
ECHA InfoCard | 100.013.880 |
EC Number |
|
KEGG | |
PubChem CID | |
RTECS number |
|
UNII | |
UN number | 3288 2291 3077 |
CompTox Dashboard (EPA) | |
InChI
| |
SMILES
| |
Properties | |
Chemical formula | PbO |
Molar mass | 223.20 g/mol |
Appearance | red or yellow powder |
Density | 9.53 g/cm |
Melting point | 888 °C (1,630 °F; 1,161 K) |
Boiling point | 1,477 °C (2,691 °F; 1,750 K) |
Solubility in water | α-PbO: 0.0504 g/L (25 °C) β-PbO: 0.1065 g/L (25 °C) |
Solubility | insoluble in dilute alkalis, alcohol soluble in concentrated alkalis soluble in HCl, ammonium chloride |
Magnetic susceptibility (χ) | 4.20×10 cm/mol |
Structure | |
Crystal structure | Tetragonal, tP4 |
Space group | P4/nmm, No. 129 |
Hazards | |
GHS labelling: | |
Pictograms | |
Signal word | Danger |
Hazard statements | H302, H332, H351, H360Df, H362, H373, H410 |
Precautionary statements | P201, P202, P260, P261, P263, P264, P270, P271, P273, P281, P301+P312, P304+P312, P304+P340, P308+P313, P312, P314, P330, P391, P405, P501 |
NFPA 704 (fire diamond) | 3 0 0 |
Flash point | Non-flammable |
Lethal dose or concentration (LD, LC): | |
LDLo (lowest published) | 1400 mg/kg (dog, oral) |
Safety data sheet (SDS) | ICSC 0288 |
Related compounds | |
Other anions | Lead(II) sulfide Lead selenide Lead telluride |
Other cations | Carbon monoxide Silicon monoxide Germanium monoxide Tin(II) oxide |
Related lead oxides | Lead(II,IV) oxide Lead dioxide |
Related compounds | Thallium(III) oxide Bismuth(III) oxide |
Except where otherwise noted, data are given for materials in their standard state (at 25 °C , 100 kPa). N verify (what is ?) Infobox references |
Lead(II) oxide, also called lead monoxide, is the inorganic compound with the molecular formula PbO. PbO occurs in two polymorphs: litharge having a tetragonal crystal structure, and massicot having an orthorhombic crystal structure. Modern applications for PbO are mostly in lead-based industrial glass and industrial ceramics, including computer components. It is an amphoteric oxide.
Types
Lead oxide exists in two types:
- Red tetragonal (α-PbO), obtained at temperatures below 486 °C (907 °F)
- Yellow orthorhombic (β-PbO), obtained at temperatures above 486 °C (907 °F)
Synthesis
PbO may be prepared by heating lead metal in air at approximately 600 °C (1,100 °F). At this temperature it is also the end product of decomposition of other oxides of lead in air:
Thermal decomposition of lead(II) nitrate or lead(II) carbonate also results in the formation of PbO:
PbO is produced on a large scale as an intermediate product in refining raw lead ores into metallic lead. The usual lead ore is galena (lead(II) sulfide). At a temperature of around 1,000 °C (1,800 °F) the sulfide is converted to the oxide:
- 2 PbS + 3 O
2 → 2 PbO + 2 SO2
From lead
There are two principal methods to make lead monoxide both of which resemble combustion of the lead at high temperature:
- Barton pot method.
- The refined molten lead droplets are oxidized in a vessel under a forced air flow which carries them out to the separation system (e.g. cyclonic separators) for further processing. Oxides produced by this method are mostly a mixture of α-PbO and β-PbO. The overall reaction is:
2Pb + O2450 °C (842 °F)→2PbO
- Ball mill method
- The lead balls are oxidized in a cooled rotating drum. The oxidation is achieved by collisions of the balls. Just like in Barton pot method, the supply of air and separators may also be used.
Structure
As determined by X-ray crystallography, both polymorphs, tetragonal and orthorhombic feature a pyramidal four-coordinate lead center. In the tetragonal form the four lead–oxygen bonds have the same length, but in the orthorhombic two are shorter and two longer. The pyramidal nature indicates the presence of a stereochemically active lone pair of electrons. When PbO occurs in tetragonal lattice structure it is called litharge; and when the PbO has orthorhombic lattice structure it is called massicot. The PbO can be changed from massicot to litharge or vice versa by controlled heating and cooling. The tetragonal form is usually red or orange color, while the orthorhombic is usually yellow or orange, but the color is not a very reliable indicator of the structure. The tetragonal and orthorhombic forms of PbO occur naturally as rare minerals.
Crystal structure in litharge form- Pb coordinates square-pyramidally
- O coordinates distorted-tetrahedrally
- Unit cell
- 3×3×3 unit cells
- Along the a axis
- Along the c axis
Reactions
Metallic lead is obtained by reducing PbO with carbon monoxide at around 1,200 °C (2,200 °F):
- PbO + CO → Pb + CO2
The red and yellow forms of this material are related by a small change in enthalpy:
- PbO(red) → PbO(yellow) ΔH = 1.6 kJ/mol
PbO is amphoteric, which means that it reacts with both acids and with bases. With acids, it forms salts of Pb
via the intermediacy of oxo clusters such as
. With strong bases, PbO dissolves to form plumbite (also called plumbate(II)) salts:
- PbO + H2O + OH
→
Applications
The kind of lead in lead glass is normally PbO, and PbO is used extensively in making glass. Depending on the glass, the benefit of using PbO in glass can be one or more of increasing the refractive index of the glass, increasing the dispersion (i. e. reducing the Abbe number) of the glass, decreasing the viscosity of the glass, increasing the electrical resistivity of the glass, and increasing the ability of the glass to absorb X-rays. Adding PbO to industrial ceramics (as well as glass) makes the materials more magnetically and electrically inert (by raising their Curie temperature) and it is often used for this purpose. Historically PbO was also used extensively in ceramic glazes for household ceramics, and it is still used, but not extensively any more. Other less dominant applications include the vulcanization of rubber and the production of certain pigments and paints. PbO is used in cathode-ray tube glass to block X-ray emission, but mainly in the neck and funnel of the tube, because it can cause discoloration when used in the faceplate. Strontium oxide and Barium oxide are preferred for the faceplate.
The consumption of lead, and hence the processing of PbO, correlates with the number of automobiles, because lead remains the key component of automotive lead–acid batteries.
Niche or declining uses
A mixture of PbO with glycerine sets to a hard, waterproof cement that has been used to join the flat glass sides and bottoms of aquariums, and was also once used to seal glass panels in window frames. It is a component of lead paints.
PbO was one of the raw materials for century eggs, a type of Chinese preserved egg. but it has been gradually replaced due to health problems. It was an unscrupulous practice in some small factories but it became rampant in China and forced many honest manufacturers to label their boxes "lead-free" after the scandal went mainstream in 2013.
In powdered tetragonal litharge form, it can be mixed with linseed oil and then boiled to create a weather-resistant sizing used in gilding. The litharge would give the sizing a dark red color that made the gold leaf appear warm and lustrous, while the linseed oil would impart adhesion and a flat durable binding surface.
PbO is used in certain condensation reactions in organic synthesis.
PbO is the input photoconductor in a video camera tube called the Plumbicon.
Health issues
Main article: Lead poisoningLead oxide may be fatal if swallowed or inhaled. It causes irritation to skin, eyes, and respiratory tract. It affects gum tissue, the central nervous system, the kidneys, the blood, and the reproductive system. It can bioaccumulate in plants and in mammals.
References
- Dorothy Greninger; Valerie Kollonitsch; Charles Howard Kline (1977). Lead Chemicals. International Lead Zinc Research Organization. p. 52.
- "Lead compounds (as Pb)". Immediately Dangerous to Life or Health Concentrations (IDLH). National Institute for Occupational Safety and Health (NIOSH).
- ^ Carr, Dodd S. (2005). "Lead Compounds". Ullmann's Encyclopedia of Industrial Chemistry. Weinheim: Wiley-VCH. doi:10.1002/14356007.a15_249. ISBN 978-3527306732.
- ^ Greenwood, Norman N.; Earnshaw, Alan (1997). Chemistry of the Elements (2nd ed.). Butterworth-Heinemann. pp. 382–387. ISBN 978-0-08-037941-8.
- Abdel-Rehim, A. M. (2006). "Thermal and XRD analysis of Egyptian galena". Journal of Thermal Analysis and Calorimetry. 86 (2): 393–401. doi:10.1007/s10973-005-6785-6. S2CID 96393940.
- ^ Dix, J. E. (1987-02-01). "A comparison of barton-pot and ball-mill processes for making leady oxide". Journal of Power Sources. 19 (2): 157–161. Bibcode:1987JPS....19..157D. doi:10.1016/0378-7753(87)80024-1. ISSN 0378-7753.
- ^ Pavlov, D. (2017). Lead-acid batteries : science and technology : a handbook of lead-acid battery technology and its influence on the product (2 ed.). Saint Louis. ISBN 978-0-444-59560-7. OCLC 978538577.
{{cite book}}
: CS1 maint: location missing publisher (link) - Wells, A. F. (1984), Structural Inorganic Chemistry (5th ed.), Oxford: Clarendon Press, ISBN 0-19-855370-6
- A simple example is given in Anil Kumar De (2007). "§9.2.6 Lead (Pb): Lead Monoxide PbO". A Textbook Of Inorganic Chemistry. New Age International. p. 383. ISBN 978-81-224-1384-7. A more complex example is in Turova, N.Y. (2002). "§9.4 Germanium, tin, lead alkoxides". The Chemistry of Metal Alkoxides. Springer. p. 115. ISBN 978-0-7923-7521-0.
- Rowe, David John (1983). Lead Manufacturing in Britain: A History. Croom Helm. p. 16. ISBN 978-0-7099-2250-6.
- Pirovano, Caroline; Islam, M. Saiful; Vannier, Rose-Noëlle; Nowogrocki, Guy; Mairesse, Gaëtan (2001). "Modelling the crystal structures of Aurivillius phases". Solid State Ion. 140 (1–2): 115–123. doi:10.1016/S0167-2738(01)00699-3.
- "ICSD Entry: 94333". Cambridge Structural Database: Access Structures. Cambridge Crystallographic Data Centre. Retrieved 2021-06-01.
- Lead Processing @ Universalium.academic.ru. Alt address: Lead processing @ Enwiki.net.
- Holleman, Arnold Frederik; Wiberg, Egon (2001), Wiberg, Nils (ed.), Inorganic Chemistry, translated by Eagleson, Mary; Brewer, William, San Diego/Berlin: Academic Press/De Gruyter, ISBN 0-12-352651-5
- Chapter 9, "Lead Compounds", in the book Ceramic and Glass Materials: Structure, Properties and Processing, published by Springer, year 2008.
- Compton, Kenneth (5 December 2003). Image Performance in CRT Displays. SPIE Press. ISBN 9780819441447 – via Google Books.
- Sutherland, Charles A.; Milner, Edward F.; Kerby, Robert C.; Teindl, Herbert; Melin, Albert; Bolt, Hermann M. "Lead". Ullmann's Encyclopedia of Industrial Chemistry. Weinheim: Wiley-VCH. doi:10.1002/14356007.a15_193.pub2. ISBN 978-3527306732.
- Corson, B. B. (1936). "1,4-Diphenylbutadiene". Organic Syntheses. 16: 28; Collected Volumes, vol. 2, p. 229.
- "Lead(II) oxide". International Occupational Safety and Health Information Centre. Archived from the original on 2011-12-15. Retrieved 2009-06-06.
External links
- Case Studies in Environmental Medicine - Lead Toxicity
- ToxFAQs: Lead
- National Pollutant Inventory - Lead and Lead Compounds Fact Sheet
- Webelements PbO
Lead compounds | |
---|---|
Pb(II) | |
Pb(II,IV) | |
Pb(IV) |