Port Aggregation Protocol (PAgP) is a Cisco Systems proprietary networking protocol, which is used for the automated, link aggregation of Ethernet switch ports, known as an EtherChannel. PAgP is proprietary to Cisco Systems. A similar protocol known as Link Aggregation Control Protocol (LACP) — released by the IEEE — is an industry standard and is not tied to a specific vendor.
PAgP messages are always sent to the well-known Cisco multicast address 01-00-0C-CC-CC-CC with protocol type code 0x0104. PAgP uses the same multicast group MAC address of CDP.
Cisco implementation
PAgP can be configured on a Cisco switch to operate in three different modes:
- auto - passive negotiation of the channel
- desirable - active negotiation of the channel
- on - no protocols are used: it assumes the other side has enabled link aggregation.
On Cisco network devices running CatOS, a single switch module may only be configured to run in either LACP or PAgP modes. Cisco devices that run IOS (native and/or non-hybrid mode boxes) support individual port configuration for LACP and are not restricted to per-module settings as with CatOS.
Limitations
A limitation of Port Aggregation Protocol is that all the physical ports in the aggregation group must reside on the same switch. Cisco's 6500 and the 4500E platforms, remove this limitation using Virtual Switching System (VSS), which allows port channels to be split between two chassis.
PAgP is not supported in Cisco Nexus Switches.
Advantages
With Port Aggregation Protocol "the line speed of an agport is the total of the line speeds of each of its physical ports." This does not automatically mean that a single transfer will use all of the aggregated interfaces bandwidth; rather, this depend on the distribution method of choice. Most Cisco switches use src/dst MAC address hash as distribution method, meaning that a single session will use the bandwidth of a single interface. Other Cisco switches uses a proprietary distribution method which enable true frame round-robin, enabling maximum link speed to be the same as the sum of the interfaces composing the aggregation group. This mean packet order can be altered, however.
Plain EtherChannel load-balancing works by having the switch assign a hash result from 0-7 based on the configured hash method (load-balancing algorithm) for the type of traffic. This hash result is commonly called a Result Bundle Hash (RBH). They are then divided out over the available links. Therefore, no single flow can exceed the speed of a physical port. However, some PagP-enabled switches can negotiate between a "maximize load balancing" and "preserve ordering" link: the former give maximum aggregated bandwidth at the expense of packet ordering, while the latter assures no packet reordering to occur but limit a single transfer to the bandwidth of a single interface.
References
- "Catalyst 6500 Virtual Switching System 1440 - Products & Services". Cisco. Retrieved 2016-01-29.
- "Port Aggregation Protocol" (PDF). Ieee802.org. Retrieved 2015-01-30.
- "Understanding EtherChannel Load Balancing and Redundancy on Catalyst Switches". Cisco. Retrieved 2018-06-20.
- "Catalyst 6500, 4500, and 3750 Series Switches EtherChannel Load-Balancing". Cisco. Retrieved 2015-12-28.