Misplaced Pages

Single-point urban interchange

Article snapshot taken from Wikipedia with creative commons attribution-sharealike license. Give it a read and then ask your questions in the chat. We can research this topic together.
(Redirected from SPUI) Highway interchange design This article reflects countries that drive on the right. For countries that drive on the left, reverse right and left.

Schematic of a freeway-under SPUI where traffic drives on the right. Traffic entering the freeway is in red. Traffic exiting the freeway is in green. Through traffic is in gray. All traffic motion of the same color can proceed simultaneously.

A single-point urban interchange (SPUI, /ˈspuːi/ SPOO-ee or /ˈspjuːi/ SPEW-ee), also called a single-point interchange (SPI) or single-point diamond interchange (SPDI), is a type of highway interchange. The design was created in order to help move large volumes of traffic through limited amounts of space efficiently.

Description

A typical freeway-over SPUI. This example, near Orlando, has since been demolished.
California State Route 87 at Taylor Street, a freeway-under SPUI

A SPUI is similar in form to a diamond interchange but has the advantage of allowing opposing left turns to proceed simultaneously by compressing the two intersections of a diamond into one single intersection over or under the free-flowing road.

The term "single-point" refers to the fact that all through traffic on the arterial street, as well as the traffic turning left onto or off the interchange, can be controlled from a single set of traffic signals. Due to the space efficiency of SPUIs relative to the volume of traffic they can handle, the interchange design is used extensively in the reconstruction of existing freeways as well as constructing new freeways, particularly in dense urban environments.

Sometimes a SPUI will allow traffic to proceed straight through from the offramp to the onramp; this usually happens when the ramps connect with frontage roads. Since most through traffic travels over or under the intersection, the SPUI is still much more efficient than a surface intersection.

Advantages

The most commonly cited advantages of SPUIs are improved operation efficiency and safety as well as reduced right-of-way requirements compared to other interchange forms. Left-turning traffic from both directions of the intersecting roadways is able to turn simultaneously without crossing the path of the opposing left turns. Because traffic passing through the interchange can be controlled by a single signal, vehicles can clear the intersection much more quickly than in a diamond interchange (which requires two sets of traffic signals).

SPUIs also allow for wider turns, easing movement for large vehicles, such as trucks and RVs. Furthermore, a SPUI takes up considerably less space than a full cloverleaf interchange, allowing construction to take place on a limited amount of property and minimizing state use of eminent domain.

Finally, SPUIs are reportedly safer than other space-efficient interchange forms, such as (standard) diamond interchanges. Research suggests that, although there may not be a significant difference between the two types of interchanges in terms of total collisions, the injury and fatality rates are notably lower for SPUIs than diamond interchanges.

Disadvantages

The major disadvantage of SPUIs over other types of road junctions is the increased cost due to the need for a longer or wider bridge. A freeway-under SPUI (as in the upper diagram) requires a wider bridge over the free-flowing road to make room for the compressed on- and offramps. However, this disadvantage poses less of a problem in cases where the arterial, or nonfreeway road, already requires a very wide bridge. The intersection of 97 Street, having seven throughlanes, with Yellowhead Trail in Edmonton, Alberta, Canada, though a diamond interchange in concept, required such a wide bridge that traffic-signal phasing allows this intersection to behave as a SPUI. A freeway-over SPUI (as in the lower photo) requires a longer bridge of the free-flowing road to cross the wider area required for the SPUI intersection below.

Because vehicles must be able to cross the pavement in six different ways, a SPUI generally has a very large area of uncontrolled pavement in the middle of the intersection. This can be unsafe particularly if drivers are unfamiliar with the interchange type. Drivers making a left turn may become confused as oncoming turning traffic passes them on the righthand side.

Due to the large intersection area, the traffic lights need a longer yellow and red phase to clear the intersection, and, even then, it may not be long enough for a bicyclist entering on green or yellow to make it across before opposing traffic gets a green. In general, SPUI designs should not be used where bicycle traffic is expected unless fairly substantial changes to the design or special accommodations are provided.

Pedestrians are usually not able to get through the intersection with one green light. It can take up to four cycles to walk through the entire length of a SPUI.

Finally, SPUIs can be somewhat difficult to clear of snow. The large area in which lanes cross may have to be shut down to allow efficient and thorough cleaning lest a snowplow leave piles of snow, interfering with traffic and visibility in the middle of the uncontrolled pavement. Additionally, if the wide area of uncontrolled pavement is on a bridge, as in the diagram, the snow cannot be pushed to the sides of the bridge as it may pose a hazard to the road underneath. This problem can be exacerbated by the comparatively large bridge width required by the SPUI.

Given that a SPUI allows only left and right turns, drivers may not reenter the freeway they are departing (if, for example, they realize that they have taken the wrong exit) within a SPUI.

Three-phase traffic signals are required. Other interchange types designed for efficiency, such as the six-ramp partial cloverleaf and the diverging diamond, require just two signal phases.

History

The first SPUI opened on February 25, 1974, along U.S. Route 19 (State Road 55), which goes over State Road 60 east of Clearwater, Florida. It was designed by Wallace Hawkes, Director of Transportation Engineering at J. E. Greiner Company (later URS Corporation), who has been called the "granddaddy of the urban interchange". This design has since been altered to include frontage roads in each direction.

Several SPUIs, built in the 1970s and later, are located on German autobahns, like the A40, A42, A44, A46, A57, A59, and A113 in Berlin. There is also a SPUI on the Frankenschnellweg, the urban part of the A73, and Maximilianstraße, in Nuremberg (at 49°27′06″N 11°02′17″E / 49.451708°N 11.038102°E / 49.451708; 11.038102). Smaller versions of the SPUI can also be found on non-autobahn roads in German cities, with right-turning traffic under signal control, located in Heilbronn, Karlsruhe, Sindelfingen, Stuttgart, and Wiesbaden.

SPUIs are also found in Australia, Canada, Hong Kong, Indonesia, and Singapore.

Variants

Inverted SPUI

Inverted SPUI where traffic drives on the right. Ramps are located between carriageways.

A rarely built variant of the SPUI is the inverted SPUI, in which the carriageways of the free-flowing road are separated, with left on- and offramps running between the carriageways and coming to a single at-grade intersection with the cross street. This can be built less expensively than a standard SPUI by allowing for shorter, simpler bridges at the interchange. However, this inverts the usual convention of placing carriageway on- and offramps on the right side of the carriageway, instead placing them on the left side, usually considered the passing lane.

Notable examples

Continuous green T (or seagull) hybrid

There is also a variant of the inverted SPUI, which can be used when a side road ends at, rather than crossing, a free-flowing road. In this variant, one carriageway of the free-flowing road is grade-separated from the side road, as with a typical inverted SPUI, while the other carriageway of the free-flowing road is at-grade with but still separated from the side road, as found in a continuous green T- (or seagull) intersection.

There is one such interchange in Pultney Township, Belmont County, Ohio, between State Route 7 (SR 7) and Interstate 470 (I-470) at 40°02′52″N 80°44′01″W / 40.047657°N 80.733542°W / 40.047657; -80.733542. The ramps leading to and from I-470 run west of, but are not directly connected to, SR 7; these ramps form the "side road" at this interchange. The southbound carriageway of SR 7 bridges over the interchange, while its northbound carriageway remains at-grade. SR 7's left on- and offramps run between its carriageways, meeting the I-470 ramps at an at-grade intersection. The I-470 ramps proceed to a trumpet interchange with I-470. I-470 itself bridges over both carriageways of SR 7 a short distance north of the I-470/SR 7 ramps' intersection. This design was likely chosen not for cost savings but because the northbound carriageway of SR 7 is bordered by railroad tracks, commercial properties, and the Ohio River and because I-470 bridges the river just east of SR 7—a more conventional interchange design was likely more difficult to achieve.

There is another such interchange in Millvale, Pennsylvania, near Pittsburgh, at the junction between Pennsylvania Route 28 (PA 28) and the 40th Street Bridge. The northbound carriageway of PA 28 passes under the interchange, with lefthand ramps meeting at the bridge (the northbound entrance ramp does not provide direct access to PA 28). The southbound carriageway of PA 28 has a continuous green T-intersection with the bridge.

A similar interchange exists in Coal Grove, Ohio, at the junction of U.S. Route 52 (US 52) with the Ben Williamson Memorial Bridge and the Simeon Willis Memorial Bridge, which cross the Ohio River and lead to and from Ashland, Kentucky, respectively. The eastbound carriageway of US 52 passes under the interchange, with lefthand exit and entrance ramps to the bridges. The westbound carriageway of US 52, which narrows to one throughlane, has a continuous green T-intersection with the bridges. The ramps cross each other at-grade, with a traffic light-controlled intersection.

An interchange, like that in Millvale, Pennsylvania, formerly existed at the junction of SR 7 and SR 822 at the now-demolished Fort Steuben Bridge in Steubenville, Ohio. The northbound carriageway of SR 7 passed under the bridge, with lefthand ramps meeting the bridge approach, while the southbound carriageway had a continuous green T-intersection with the bridge.

Offset SPUI

Offset SPUI

An offset SPUI is similar to a diamond interchange, however, by making two of the ramps flyovers or flyunders, all ramps are pushed to one side of the highway, where they meet the surface street at a single intersection. An example of this is the interchange between Interstate 225 and Alameda Avenue near the Town Center at Aurora shopping center in Aurora, Colorado, United States (at 39°42′40″N 104°49′33″W / 39.711189°N 104.825807°W / 39.711189; -104.825807).

Three-level SPUI

A three-level SPUI is similar to a standard SPUI but includes an additional grade separation allowing for free-flowing through traffic on the crossroad; such through traffic thus bypasses the signalized intersection. The remaining intersection, free of the crossroad's through traffic, uses a two-phase traffic signal for handling the left turns in pairs, similar to the traffic flow at an inverted SPUI.

Examples include:

References

  1. "Overview of Reduced Conflict Intersection Design & Operations" (PDF). Wisconsin Department of Transportation. Archived (PDF) from the original on February 1, 2017. Retrieved May 5, 2016.
  2. Anonymous (July 1989). "Urban interchange moves more traffic in same space; a design new to California improves congested diamond interchanges without taking more high-priced real estate". Highway & Heavy Construction. 132 (8): 52–53. ISSN 0362-0506.
  3. St. Louis District. "Single Point Urban Interchanges". Missouri Department of Transportation. Archived from the original on July 1, 2017. Retrieved July 15, 2012.
  4. ^ Bonneson, James A. (January 1993). "Bridge Size and Clearance Time of Single Point Urban Interchange". Journal of Transportation Engineering. 119 (1). American Society of Civil Engineers: 77–93. doi:10.1061/(ASCE)0733-947X(1993)119:1(77). ISSN 0733-947X.
  5. St. Louis District. "Single Point Urban Interchange Frequently Asked Questions". Missouri Department of Transportation. Archived from the original on July 23, 2012. Retrieved July 15, 2012.
  6. Bared, Joe; Powell, Alvin; Kaisar, Evangelos; Jagannathan, Ramanujan (May 2005). "Crash Comparison of Single Point and Tight Diamond Interchanges". Journal of Transportation Engineering. 131 (5). American Society of Civil Engineers: 379–381. doi:10.1061/(ASCE)0733-947X(2005)131:5(379). ISSN 0733-947X. S2CID 110625815.
  7. ^ Qureshi, Mohammad; Sugathan, Navin; Lasod, Rohit; Spring, Gary (September 2004). "Design of Single Point Urban Interchanges, Research Investigation 02-015" (PDF). Missouri Department of Transportation Research, Development, and Technology, University of Missouri-Rolla. Archived (PDF) from the original on May 30, 2010. Retrieved February 10, 2010.
  8. "Google Maps". Google Maps. Retrieved February 27, 2022.
  9. Lothson, Anna (June 7, 2012). "IDOT to discuss I-290 interchanges at Austin, Harlem in Oak Park". Wednesday Journal Inc. Archived from the original on January 30, 2016. Retrieved July 27, 2015.
  10. Reid, Jonathan (July 2004). "Unconventional Arterial Intersection Design, Management and Operations Strategies" (PDF). Parsons Brinckerhoff. Archived from the original (PDF) on November 15, 2015. Retrieved September 9, 2012.
  11. Schmitz, Jon (September 28, 2011). "Whole new Route 28 beginning to emerge through construction". Pittsburgh Post-Gazette. Archived from the original on October 6, 2011. Retrieved August 4, 2015.
  12. Technical Services. "Straight Line Diagrams: Lawrence County, US 52" (PDF) (PDF). Ohio Department of Transportation. Archived (PDF) from the original on March 20, 2016. Retrieved February 14, 2019.
  13. Technical Services. "Straight Line Diagrams: Jefferson County, SR 7" (PDF) (PDF). Ohio Department of Transportation. Archived (PDF) from the original on October 27, 2013. Retrieved August 4, 2015.
  14. "South Dakota Department of Transportation - Home". dot.sd.gov. Archived from the original on February 27, 2022. Retrieved February 27, 2022.
  15. Interstate 64/Route 40 Corridor, City of St. Louis and St. Louis County: Environmental Impact Statement. 2005.
  16. "Pharmacy regulator sets up FTP advisory group". The Pharmaceutical Journal. 2014. doi:10.1211/pj.2014.20066574. ISSN 2053-6186.

External links

Map all coordinates using OpenStreetMap

Download coordinates as:

Road hierarchy
Types of road
Limited-access
By country
Main roads
Local roads
Other terms
Road junctions
Interchanges
(grade-separated)
Intersections
(at-grade)
Surfaces
Road safety
factors
Road and
environment
Human factors
Vehicles
Space and
time allocation
Demarcation
Structures
Performance
indicators
Category: