Misplaced Pages

This article does not cite any sources. Please help improve this article by adding citations to reliable sources. Unsourced material may be challenged and removed. Find sources: "Vertical and horizontal" radio propagation – news · newspapers · books · scholar · JSTOR (December 2009) (Learn how and when to remove this message)

Part of a series on
Antennas
Common types Dipole Fractal Loop Monopole Satellite dish Television Whip
Components Balun Block upconverter Coaxial cable Counterpoise (ground system) Feed Feed line Low-noise block downconverter Passive radiator Receiver Rotator Stub Transmitter Tuner Twin-lead
Systems Antenna farm Amateur radio Cellular network Hotspot Municipal wireless network Radio Radio masts and towers Wi-Fi Wireless
Safety and regulation Wireless device radiation and health Wireless electronic devices and health International Telecommunication Union (Radio Regulations) World Radiocommunication Conference
Radiation sources / regions Boresight Focal cloud Ground plane Main lobe Near and far field Side lobe Vertical plane
Characteristics Array gain Directivity Efficiency Electrical length Equivalent radius Factor Friis transmission equation Gain Height Radiation pattern Radiation resistance Radio propagation Radio spectrum Signal-to-noise ratio Spurious emission
Techniques Beam steering Beam tilt Beamforming Small cell Bell Laboratories Layered Space-Time (BLAST) Massive Multiple-input multiple-output (MIMO) Reconfiguration Spread spectrum Wideband Space Division Multiple Access (WSDMA)
v t e

In radio propagation, horizontal plane is used to plot an antenna's relative field strength in relation to the ground (which directly affects a station's coverage area) on a polar graph. Normally the maximum of 1.000 or 0 dB is at the top, which is labeled 0, running clockwise back around to the top at 360°. Other field strengths are expressed as a decimal less than 1.000, a percentage less than 100%, or decibels less than 0 dB. If the graph is of an actual or proposed installation, rotation is applied so that the top is 0 true north.

The vertical plane is used to plot an antenna's relative field strength perpendicular to the ground (which directly affects a station's coverage area) on a polar graph.

Normally, the maximum of 1.000 or 0 dB is at the side (unless there is beam tilt), which is labeled 0°, to 90° at the top and −90° at the bottom. Other field strengths are expressed as a decimal less than 1.000, a percentage less than 100%, or decibels less than 0 dB.

Most broadcast antennas use either line-of-sight or ground wave propagation (a slight refraction towards the ground) to reach their nearby listeners, and thus want a low angle in the vertical plane. Short wave transmitters want a somewhat higher elevation angle in the vertical plane to encourage skywave propagation, which would refract or reflect radio waves off the ionosphere and back to the ground at a great distance from the transmitter.

Omnidirectional antennas typically try to limit the range of their vertical plane radiation pattern to concentrate energy over a smaller range and increase gain.

• Antennas (radio)